Marine M-27 Infantry Automatic Rifle Reliability Testing Results

Results from Round One, in 2008:

e. All participants submitted three samples for testing.

f. Results for all Class I and II failures are listed below across all 3 UUTs from 9 of the 10 IAR Bid Samples.

1. Colt proposal A: 60 Failures
2. Colt proposal B: 28 Failures
3. Competitor C: 23 Failures
4. Competitor D: 78 Failures
5. Competitor E: 39 Failures
6. Competitor F: 12 Failures
7. Heckler & Koch Defence Inc. proposal G: 27 Failures
8. Competitor H: 124 Failures
9. FN Herstal proposal J: 26 Failures

g. The 10th IAR Bid Sample, Competitor I, was determined unsafe for live fire due to a lack of proof marking. Live fire testing was not conducted.

Kind of a raw break for that unfortunate competitor, Code Letter I.

Note that some of the rejected proposals (C, E, F) had fewer failures than the ones that proceeded. This is presumably due to the distribution of the failures. (If you have only a few failures, but they’re take-the-gun-to-the-bench failures, that’s a whole other thing than a higher quantity of simple failures that are rectified in seconds by operator immediate action (a la SPORTS drill on the M16/M4 series).

This is the Round One definition of failures by class:

Reliability Testing

The Unit Under Test (UUT) shall have a Mean Rounds Between Failure (MRBF) of 900 for Class I and II failures combined (Threshold), 5,000 MRBF (Objective).

1. Class I failure: A failure that may be immediately corrected by the operator within 10 seconds or less while following prescribed immediate action procedures.
2. Class II failure: A failure that may be corrected by the operator, and that requires more than 10 seconds but not more than 10 minutes to correct (less the TM/OM defined cool down period if a hot barrel condition exists). Only the equipment and tools issued with the weapon may be used to correct the failure.

A very similar definition of failures, with a third, more serious, class, was used for Round Two in 2009.

Reliability/Endurance Testing Mean Rounds Between Failure (MRBF)

a. Three Units Under Test (UUTs) were provided for each model under evaluation.

b. The UUT shall have a Mean Rounds Between Failure (MRBF) of 900 for Class I and II failure combined (Threshold), 5,000 (Objective). The MRBF for Class III failures shall be 15,000 (Threshold), 20,000 (Objective).

1. Class I failure: A failure that may be immediately corrected by the operator within 10 seconds or less while following prescribed immediate action procedures.
2. Class II failure: A failure that may be corrected by the operator, and that requires more than 10 seconds but not more than 10 minutes to correct (less the TM/OM defined cool down period if a hot barrel condition exists). Only the equipment and tools issued with the weapon may be used to correct the failure.
3. Class III failure: A failure of a severe nature. The failure (1) can be corrected by an operator but requires more than 10 minutes; (2) cannot be corrected by an operator and requires assistance (no time limit); or (3) requires higher level of maintenance or correction by an authorized operator cannot be accomplished because of unavailability of necessary tools, equipment, or parts.